Loading Events

« All Events

  • This event has passed.

Geometric Dimensioning and Tolerancing (GD&T)

February 12 @ 8:30 am - 5:00 pm


2/13 & 2/14/2024

About Course:

Geometric Dimensioning and Tolerancing (GD&T) is an international language used on engineering drawings.

Classes will include... Introduction; Dimensioning and Tolerancing Fundamentals; Symbols, Terms, and Rules; Datums; Form controls – Flatness, Straightness, Circularity, Cylindricity, Free state variation; Orientation – Parallelism, Perpendicularity, Angularity; Position, General – Specifying the position tolerance, Regardless of feature size, Maximum material condition, Shift tolerance, Boundary conditions, “0” Positional Tolerancing; Position, Location – Fasteners, Projected Tolerance Zones, Multiple patterns of features, Composite positional tolerancing, Two single-segment feature control frames, Nonparallel holes, Counterbored holes, Noncircular features, Symmetrical features; Position, Coaxiality; Concentricity and Symmetry; Runout; Profile.

Course Outcome:

  • Providing uniformity in drawing specifications and interpretation, and geometric tolerancing to reduce controversy, guesswork, and assumptions throughout the manufacturing and inspection process.
  • When GD&T is used properly it will improve communication and result in better product design. Proper use of GD&T also increases product tolerances, saving your organization time and money.

Please contact Kathleen Baldwin, Sales Support Manager at NJMEP with any questions or need of further assistance.  kbaldwin@njmep.org  973-998-9801 ext. 211


February 12
8:30 am - 5:00 pm


NJMEP North 2 Ridgedale Ave, Suite 305, Cedar Knolls, NJ 07927
2 Ridgedale Ave
Cedar Knolls, NJ 07927 United States
+ Google Map


The numbers below include tickets for this event already in your cart. Clicking "Get Tickets" will allow you to edit any existing attendee information as well as change ticket quantities.
Tickets are no longer available

Request Your Complimentary Assessment

Schedule Now